SUFFOLK ESSENTIAL P10 OAK Unfinished
Product code: DRU000255
Categories: Oak Unfinished Glazed
£124.00 - £129.00
Description
A contemporary partner to our Suffolk door The large glass panel allows lot’s of natural light to flow through your home. The etched glass design complements the Suffolk range creating a seamless look througout. This door can also be partnered with our Pattern 10 family of doo designs.
Glazed With Clear Etched Glass
Top features
- Engineered construction for added strength and stability
- A fully finished door provides a consistent look whilst removing the time and hassle required to finish a door
- A-Grade American White Oak Veneer
- FSC Certified product with full chain of custody
- Real Oak Lipping allowing for 6mm to be trimmed off all edges of the door
-
Installation
- Door HandingReversible
- TrimmableYes
- Overall Total Trimming Width (mm)30
- Overall Trimming Height (mm)30
- Maximum Trimming From Top (mm)15
- Maximum Trimming From Bottom (mm)15
- Maximum Trimming From Each Side (mm)15
- Recommended Latch Size65mm
- Door PreparationLight sanding using 240 or 320 grit sand paper to cut outs and trimmed edges only
- Number of Hinges Required3
- Type of Hinge Required3" Butt
- Recommended FinishWoodstain, Paint, Varnish, Osmo Door Oil High Solid 3033, Osmo Door Oil High Solid 3061
- Fitting InstructionsHANDLING AND STORAGE Doors should always be stored flat, ideally in the same room where they are to be installed. Protect the door from damp and dirt by leaving it in its protective packaging until ready for finishing and fitting. Doors should not be fitted where extremes of temperature or humidity may occur, e.g. in a newly plastered room or near a sauna. In new build situations the doors should only be fitted when the property is ready for final decoration. INSTALLATION When trimming a door to fit, 15mm can be removed from each edge of the door to a maximum reduction of 30mm in both the height and width. Any reduction must be removed evenly from each edge of the door, e.g. to trim your door by 8mm in width, remove 4mm off each side. Three hinges should be used to hang all doors, to prevent warping or bowing. Latches and locks should not be fitted adjacent to door mid-rails where the joint may be compromised. All hardware screw holes should be pre-drilled to prevent splitting of the timber. FINISHING All fully finished doors will require any bare timber areas caused by trimming and hardware fitting, to be adequately treated before final fitting. Failure to treat all the timber surfaces may lead to excessive changes in moisture content which will cause the timber to shrink or swell, possibly causing splits and distortion. Any unfinished areas will require a light sanding prior to finishing using a fine grade sandpaper (grit number 240 or 320). Please refer to the finish manufacturer’s application instructions for further details. DO Use a good quality stain or varnish suitable for veneered doors. Apply first coat of finish immediately after unpacking doors from protective packaging. Apply coats equally to all faces and edges including the top and bottom of the door. Use the same number of coats for lock, latch and hinge cut-outs. DO NOT Use oils, wax, dyes or preservative treatments Use thinned/mixed paints or stains. Mix incompatible products, e.g. paint on one door face and stain on the opposite face. MAINTENANCE To prolong the natural beauty of your door regularly clean the surface with a damp cloth. If the finish appears to fade after a few years simply apply a single coat of finish to renew its lustre.
Images are for illustrative purposes only